Download plugin sketchup 2014 code#
If the faces close automatically when a diagonal line is drawn, the loop of lines are most likely not coplanar.ġ.3: Added the new progressbar.rb code support.ġ.4: Now, you don't have to select anything before you run. Use can use the Tools>Utilities>Query Tool to check the faces for their coordinates. Points may not be coplanar (on the same plane).To resolve this, download the IntersectOverlaps plugin, and then run Makefaces again. This happens all the time with imported CAD drawings. If the highlighted portion of the selected line segment extends across another line, and they touch, then this is the case. You can determine this by selecting a line that crosses another. Lines may overlap each other, but not intersect each other.If you have downloaded the CloseOpens script, it will most likely close the opens automatically. Line segments may not form a closed loop.Run StrayLines to see if any of these types of lines exist in your drawing.
There may be stray line fragments that interrupt normal face creation.Try scaling your model up 10X or more and rerun. SketchUp TM will not create very small faces, less than approximately 1/16" or less than 1mm. If, after running Makefaces, you are not satisfied with the results, there may be reasons that all the faces you thought should have been created, did not get created. Artikel ini akan membahas 10 plugins SketchUp 2014 ke bawah, yang WAJIB kamu miliki Berikut ini adalah beberapa plugin yang harus kamu punya jika kamu memasang SketchUp (versi berapa pun). Another script, ProgressBar, is required. Download Must Have Plugin SketchUp 2014 yang harus kamu miliki.A progress bar will be updated on the Status Bar while running.Makefaces will run, and will report statistics at the end of the run.Select your whole model or a portion of your model.Makefaces.rb loops through your model and creates faces where faces need to be created.